Experimental Study on Evaporative Heat Transfer and Pressure Drop of R-134a Flowing Downward Through Vertical Corrugated Tubes with Different Corrugation Pitches


Aroonrat K., DALKILIÇ A. S., Wongwises S.

EXPERIMENTAL HEAT TRANSFER, cilt.26, sa.1, ss.41-63, 2013 (SCI-Expanded) identifier identifier

  • Yayın Türü: Makale / Tam Makale
  • Cilt numarası: 26 Sayı: 1
  • Basım Tarihi: 2013
  • Doi Numarası: 10.1080/08916152.2011.631080
  • Dergi Adı: EXPERIMENTAL HEAT TRANSFER
  • Derginin Tarandığı İndeksler: Science Citation Index Expanded (SCI-EXPANDED), Scopus
  • Sayfa Sayıları: ss.41-63
  • Anahtar Kelimeler: vertical, evaporative, heat transfer, pressure drop, corrugated tube, 2-PHASE FRICTION FACTOR, VOID FRACTION MODELS, HIGH-MASS FLUX, TRANSFER COEFFICIENT, GENERAL CORRELATION, CONDENSATION, R134A
  • Yıldız Teknik Üniversitesi Adresli: Evet

Özet

This study reports an experimental investigation of evaporative heat transfer and pressure drop of R-134a flowing downward inside vertical corrugated tubes with different corrugation pitches. The double tube test section is 0.5 m long with refrigerant flowing in the inner tube and hot water flowing in the annulus. The inner tubes are comprised of one smooth tube and three corrugated tubes with different corrugation pitches of 6.35, 8.46, and 12.7 mm. The test runs are performed at evaporating temperatures of 10 degrees C, 15 degrees C, and 20 degrees C; heat fluxes of 20, 25, and 30 kW/m2; and mass fluxes of 200, 300, and 400 kg/m2s. The experimental data obtained from the smooth tube are plotted with flow pattern map for vertical flow. Comparisons between smooth and corrugated tubes on the heat transfer and pressure drop are also discussed. It is observed that the heat transfer coefficient and frictional pressure drop obtained from the corrugated tubes are higher than those from the smooth tube. Furthermore, the heat transfer coefficient and frictional pressure drop increase as the corrugation pitch decreases. The maximum heat transfer enhancement factor and penalty factor are up to 1.22 and 4.0, respectively.