SQP Optimization of 6dof 3x3 UPU Parallel Robotic System for Singularity Free and Maximized Reachable Workspace


Eryılmaz C., ÖMÜRLÜ V. E.

JOURNAL OF ROBOTICS, cilt.2019, 2019 (ESCI) identifier identifier

  • Yayın Türü: Makale / Tam Makale
  • Cilt numarası: 2019
  • Basım Tarihi: 2019
  • Doi Numarası: 10.1155/2019/3928705
  • Dergi Adı: JOURNAL OF ROBOTICS
  • Derginin Tarandığı İndeksler: Emerging Sources Citation Index (ESCI), Scopus
  • Yıldız Teknik Üniversitesi Adresli: Evet

Özet

The determination of kinematic parameters for a parallel robotic system (PRS) is an important and a critical phase to maximize reachable workspace while avoiding singular configurations. Stewart Platform (SP) mechanism is one of the widely known PRS and it is used to demonstrate the proposed technique. In the related literature, GCI (Global Condition Index) and LCI (Local Condition Index) are the commonly used performance indexes which give a measure about the dexterity of a mechanism. In this work, Sequential Quadratic Programming (SQP) method is used to optimize kinematic parameters of a 6dof 3x3 UPU SP in order to reach maximum workspace satisfying small condition numbers. The radius of mobile and base platforms and the lengths of the legs used in the platform are chosen as kinematic parameters to be optimized in a multiobjective optimization problem. Optimization is performed at different stages and the number of optimized kinematic parameters is increased at each level. In conclusion, optimizing selected kinematic parameters at once by using SQP technique presents the best results for the PRS.

The determination of kinematic parameters for a parallel robotic system (PRS) is an important and a critical phase to maximize reachable workspace while avoiding singular configurations. Stewart Platform (SP) mechanism is one of the widely known PRS and it is used to demonstrate the proposed technique. In the related literature, GCI (Global Condition Index) and LCI (Local Condition Index) are the commonly used performance indexes which give a measure about the dexterity of a mechanism. In this work, Sequential Quadratic Programming (SQP) method is used to optimize kinematic parameters of a 6dof 3x3 UPU SP in order to reach maximum workspace satisfying small condition numbers. The radius of mobile and base platforms and the lengths of the legs used in the platform are chosen as kinematic parameters to be optimized in a multiobjective optimization problem. Optimization is performed at different stages and the number of optimized kinematic parameters is increased at each level. In conclusion, optimizing selected kinematic parameters at once by using SQP technique presents the best results for the PRS.