Atıf İçin Kopyala
Unuvar Y., Calis A., Koc O.
Journal of stomatology, oral and maxillofacial surgery, ss.102157, 2024 (SCI-Expanded)
Özet
Abstract
The “All-on-four” technique addresses this by placing two vertical implants in the anterior region and two posterior implants angled up to 45°. This study evaluates stress distribution on bone, implants, abutments, gingiva, and prostheses based on posterior implant angulation, using both standard and angled neck implants. Additionally, angled neck implants were used alongside standard implants.
Methods
To evaluate the biomechanical stress and displacement behavior of implants placed at 15°, 30°, 45°, and 30° neck-angled in the interforaminal region of using the All-on-four technique, under a 200 N masticatory force on bone, implant, abutment, and prosthesis, using the FEA method with a nonlinear solver.
Results
The stress values measured in the neck region of the angled implant and abutment placed in the distal region were highest in model IV (305 and 420 MPa), followed model III (282 and 359 MPa), model II (192 and 337 MPa) and lowest in model I (177 and 225 MPa), respectively. The mean elemental von Mises stress in the mandibular bone region where the implant was placed was highest in model I (56 MPa) and lowest in model III (40.4 MPa).
Conclusion
As the angle of insertion of the implant into the bone increases, the biomechanical stress value on the implant and abutment also increases. Among the models, the lowest von Mises stress values on the implant and abutment were measured in model I and model II. Models with low stress values can be recommended for patients with clinical conditions and biomechanical risk factors.